Passat Sedan V6-3.6L (BLV) (2008)
5
Cylinder Block
‹› Crankshaft overview. Refer to => [ Crankshaft Overview ] See: Cylinder Block Assembly/Crankshaft/Service and Repair/Crankshaft Overview
.
‹› Piston and connecting rod overview. Refer to => [ Piston and Connecting Rod Overview ] See: Cylinder Block Assembly/Piston/Service and
Repair/Piston and Connecting Rod Overview.
6
Sealing Flange
‹› Removing and installing, refer to => [ Sealing Flange, Transmission Side ] See: Cylinder Block Assembly/Crankshaft Seal Retainer/Service
and Repair.
7
Seal
‹› Remove using pulling hook (T20143/2).
‹› Polytetrafluoroethylene (PTFE) version of the oil seal.
‹› Do not lubricate or grease the sealing lip on the oil seal.
‹› Before installing, remove any remaining oil from crankshaft with a clean cloth.
‹› Installing, refer to => [ Sealing Flange Seal, Transmission Side ] See: Sealing Flange Seal, Transmission Side.
8
Shim
9
Bolt
‹› 60 Nm + 90° (1/4) additional turn.
‹› Replace
‹› To loosen or tighten, use counter hold tool (T10044) (with 5 mm spacers), or Counter holder tool (T10069).
10
Washer
11
Drive Plate
‹› Removing and installing, refer to => [ Drive Plate ] See: Transmission and Drivetrain/Flex Plate/Service and Repair/Drive Plate.
12
Bolt
‹› 23 Nm