Passat Sedan V6-3.6L (BLV) (2008)
^
Only use bolts with strength category 10.9
^
Replace
15. Chain tensioner with tensioning rail
^
Before installation release the locking device in the chain tensioner with a small screwdriver and press the tensioning plate against the chain
tensioner.
^
Only rotate engine with chain tensioner installed.
16. Drive gear
^
Integral part of crankshaft
17. Timing Chain
^
Mark direction of rotation before removing (installation position)
18. Guide rail
^
Remove and install together with timing chain
19. Locating pin without collar, 10 Nm
20. 10 Nm
21. 23 Nm
22. 60 Nm + 1/4 turn (90 degree)
^
Replace
^
Contact surface of sensor wheel at bolt head must be dry when installing
^
To remove and install, counter-hold at camshaft using an open-end wrench (27 mm).
23. Guide rail
24. Drive gear
25. Intake camshaft adjuster
^
Identification: 24E
26. Camshaft adjustment valve 1 (exhaust) N318
^
For exhaust camshaft
^
Before disconnecting, mark allocation of connector to component
27. Camshaft adjustment valve 1 N205
^
For intake camshaft
^
Before disconnecting, mark allocation of connector to component
28. Guide rail
^
clipped in at control housing
Identifying the Timing Chain
-
Mark the timing chains before removing (e.g. with paint, arrow pointing in direction of rotation).
Note:
^
Do not mark chain using a center punch or similar means!