Passat Sedan V6-3.6L (BLV) (2008)
/Page-731002.png)
‹› M10 - 40 Nm
‹› Replace
4
Connector
‹› Black, 6 pin
5
Heated Oxygen Sensor (HO2S) (G39)
‹› 50 Nm
‹› Bank 1, sensor 1.
‹› Installed in the exhaust gas stream of cylinders 1, 2 and 3.
‹› Lubricate the threads only with (G 052 112 A3); do not let (G 052 112 A3) get onto the slits of the oxygen sensor body.
‹› Removing and installing, refer to => [ Heated Oxygen Sensor and Heated Oxygen Sensor 2 ] See: Powertrain Management/Computers and
Control Systems/Oxygen Sensor/Service and Repair/Removal and Replacement/Heated Oxygen Sensor and Heated Oxygen Sensor 2.
6
Oxygen Sensor (O2S) 2 Behind Three Way Catalytic Converter (TWC) (G131)
‹› 50 Nm
‹› Bank 2, sensor 2.
‹› Installed in the exhaust gas stream of cylinders 4, 5 and 6.
‹› Lubricate the threads only with (G 052 112 A3); do not let (G 052 112 A3) get onto the slits of the oxygen sensor body.
‹› Use ring spanner 7-piece set (3337) for removal and installation.
7
Connector
‹› Black, 4 pin
8
Connector
‹› Brown, 4 pin
9
Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130)
‹› 50 Nm
‹› Bank 1, sensor 2.
‹› Installed in the exhaust gas stream of cylinders 1, 2 and 3.
‹› Grease the thread only with (G 052 112 A3); do not let the (G 052 112 A3) get onto the slits of the oxygen sensor body.
‹› Use ring spanner 7-piece set (3337) for removal and installation.
10
Heat Shield
11
Intake Manifold Support
12
Bolt
‹› 20 Nm
13
Gasket
‹› Replace
