Passat Sedan V6-3.6L (BLV) (2008)
force from mounting points - C -, ensure that toothed gear - D - is not damaged when doing this.
Installing
‹› Motor as replacement part is delivered in the "fresh air mode " position, only when toothed gear - A - contacts stop - B - can it then be connected
onto toothed gear of fresh/recirculating air door. If a motor was removed in a different position or activated in the removed state, it cannot be
installed.
‹› If toothed gear - A - of motor does not stand at stop - B - "fresh air mode", proceed as follows:
-
Connect motor to vehicle wiring harness.
-
Switch ignition on.
-
Wait until toothed gear - A - of motor reaches stop - B - "fresh air mode".
-
Switch off ignition.
-
Reach into intake opening for recirculating air mode and bring fresh/recirculating air door - A - into "fresh air mode" position (intake opening for
recirculating air mode is closed).
-
Insert motor - B - into mounts - C - in opposite direction of arrow and onto toothed gear - D -.