Passat Sedan V6-3.6L (BLV) (2008)
‹› Single wire seals must always fit with the repair wire cross-section. Outer circumference of single wire seal is aligned according to chamber
circumference of the contact housing. Perform assembly using only the assembly tool with correct fit.
Assembling single wire seal:
-
Release contact lock using assembly tool with correct fit - A - and then pull wire with single wire seal toward rear - arrow - out of contact
housing.
-
Cut off the old contact with single wire seal from the vehicle-specific wiring harness.
-
Slide repair wire with new contact into corresponding chamber of contact housing until it engages.