Passat Sedan V6-3.6L (BLV) (2008)
/Page-1538010.png)
-
Put single wire seal - A - onto free end of repair wire.
‹› When doing this, small diameter of single wire seal must point toward contact housing.
-
Slide single wire seal - A - onto repair wire up to the contact housing.
-
Slide single wire seal - A - into contact housing until it stops using the corresponding assembly tool - B -.
-
Shorten the repair wire and the vehicle-specific wiring harness single wire as needed using the wire stripper (VAS 1978/3).
