Passat Sedan V6-3.6L (BLV) (2008)
/Page-1539004.png)
CAN Bus Wires
CAN Bus Wires
‹› Unshielded two-strand wiring - 1 - and - 2 - with a cross section of 0.35 mm2 or 0.5 mm2can be used as CAN-Bus wiring.
‹› The color coding of CAN-Bus wires can be found in the following table:
‹› Repairs on CAN-Bus wires can be performed with repair wire with matching cross section and also with twisted wires green/yellow or
white/yellow.
‹› When repairing Bus leads, both wires must be of the same length. When twisting together wires - 1 - and - 2 -, length of lay of A = 20 mm must be
observed.
‹› While doing this, no section of the wire, e.g. in area of crimp connectors - arrow -, may be greater than B = 50 mm without twisting of the wires.
‹› Wrap repair points with yellow adhesive tape to mark a performed repair.
Contact Housings and Connectors
Contact Housings and Connectors
‹› Observe general notes for repairs on the vehicle electrical system. Refer to => [ Vehicle Electrical System ] See: Vehicle Electrical System.
‹› Allocation of crimp contacts with correct fit to contact housing is performed according to the part number stamped in on the contact housing.
‹› Damaged contact housings must always be replaced.
‹› New contact housings may be ordered via OTC Kassel.
Vehicle Electrical System
Vehicle Electrical System
CAUTION!
When disconnecting and connecting battery, the procedure must be followed as described in the Repair Information.
CAUTION!
Some tools are supplied with a tool safety clip, which is slid over the tool points after using the tool, in order to protect other workers
from injuries and tool points from damage.
