Passat Sedan V6-3.6L (BLV) (2008)
Wire Break with Single Repair Point
Repair point with single crimp connection
-
Free up wire intended for repair (approximately 20 cm to both sides of repair point).
-
If required, remove wiring harness wrapping using a folding knife.
-
Cut out the damaged wire section using wire stripper (VAS 1978/3).
‹› If, by cutting out the damaged wire section, both ends of the vehicle-specific single wire are too short for a repair using a single crimp connection,
insert a repair wire section of matching length with two crimp connections, refer to => [ Wire Break with Dual Repair Point ] See: Wire Break
With Dual Repair Point.
-
Strip wire ends using 6 - 7 mm wire stripper.