Passat Sedan V6-3.6L (BLV) (2008)
Information Bus: Removal and Replacement
Data Bus On Board Diagnostic Interface (J533)
Removing:
‹› If Data Bus On Board Diagnostic Interface is to be replaced, the work procedure to read out the codes stored in the module must always be
performed, refer to => [ Data Bus On Board Diagnostic Interface, Replace ] See: Testing and Inspection/Initial Inspection and Diagnostic
Overview/Data Bus On Board Diagnostic Interface (J533), Replace.
-
Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).
-
Remove foot well cover on driver's side.
-
Disengage harness connector - 1 - and disconnect it from Data Bus On Board Diagnostic Interface - 2 -.
-
Press mounting pins - 3 - together - arrows - and out of holes.
-
Remove Data Bus On Board Diagnostic Interface from vehicle.
Installing:
Install in reverse order of removal.