Passat Sedan V6-3.6L (BLV) (2008)
‹› The Motronic Engine Control Module (ECM) (J623) must remain connected for the following step.
-
Using a multimeter, check the Direct Shift Gearbox (DSG) Mechatronic (J743) electrical harness connector terminals 10 to 15 for resistance.
Specified value: 60 to 72 ohms (at approx. 20° C)
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, high resistance or short circuit to voltage or ground.
-
Check the wiring connection for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring:
-
Replace the Motronic Engine Control Module (ECM) (J623). Refer to the Repair Information.
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used, perform the following step.
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to the Repair Information.
-
Using a multimeter, check the Direct Shift Gearbox (DSG) Mechatronic (J743) electrical harness connector to the Motronic Engine Control
Module (ECM) (J623) electrical harness connector T94 for resistance.
Specified value: 1.5 ohms Max.
If the specified value was Not obtained:
-
Check the wiring connection for an open circuit, high resistance or short circuit to voltage or ground.
-
Check the wiring connection for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring:
-
Replace the Motronic Engine Control Module (ECM) (J623). Refer to the Repair Information.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 09.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing
and Procedures/Diagnostic Modes 01 - 09.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes.