Passat Sedan V6-3.6L (BLV) (2008)
-
Observe safety precautions. Refer to => [ Safety Precautions ] See: Service Precautions/Safety Precautions
-
Observe Clean Working Conditions. Refer to => [ Clean Working Conditions ] See: Service Precautions/Clean Working Conditions
-
Perform a preliminary check to verify the customers complaint. Refer to => [ Preliminary Check ] See: Testing and Inspection/Scan Tool Testing
and Procedures/Preliminary Check.
Start diagnosis
-
Disconnect the HO2S Oxygen Sensor Bank 2 Sensor 1 (G108) electrical harness connector- 4 -.
Checking internal resistance
-
Using a multimeter, check the Oxygen Sensor Heater Bank 2 Sensor 1 (Z28) terminals 3 to 4 for resistance.
Specified value: 2.5 to 10.0 ohms (at approx. 20° C)
If the specification was not obtained:
-
Replace HO2S Oxygen Sensor Bank 2 Sensor 1 (G108). Refer to the Repair Information.
If the specification was obtained:
Checking voltage supply
Switch the ignition on.
-
Using a multimeter, check the Oxygen Sensor Heater Bank 2 Sensor 1 (Z28) electrical harness connector terminal to ground for voltage.