Passat Sedan V6-3.6L (BLV) (2008)
-
Remove the multifunction switch - 4 - with washers - 2 and 3 - from the shift rod - 6 -.
Installing
Installation is performed in the reverse order of removal. Pay attention to the following:
-
Install the multifunction switch - 4 - to the shift rod - 6 -.
-
Hand tighten the multifunction switch bolts - 5 -.
-
Bend the tabs of the locking washer - 2 - back.
-
Install the washers - 2 and 3 - onto the shift rod - 6 -.
-
Install the washer - 2 - with the tabs facing upward.
-
Install the washer - 2 - with the long and thin guides into the long and narrow depressions in the shift rod - 6 -.
-
Install the nut - 1 - and tighten it to 7 Nm.
-
Secure the nut - 1 - by bending the tabs on the locking washer - 2 - upward.
-
If one or more tabs on the locking washer break when bending, the locking washer must be replaced.
-
Install the lever - 3 - onto the shift rod - 4 -.