Passat Sedan V6-3.6L (BLV) (2008)
Installing
-
Thoroughly clean the fuel injector bores in the cylinder head using (T10133/4).
-
Check the plastic support washer - item 10 -=> [ Support Washer ] See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and
Repair/Two Piece Intake Manifold for damage and replace it if necessary. Refer to => [ Fuel Injector Teflon Seal and Washer ]. See: Engine,
Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Two Piece Intake Manifold/Removal and Installation/Fuel Injector Teflon Seal
and Washer
-
Replace the spring - arrow - and Teflon seal each time the fuel injector is removed. Refer to => [ Fuel Injector Teflon Seal and Washer ]. See:
Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Two Piece Intake Manifold/Removal and Installation/Fuel Injector
Teflon Seal and Washer