Passat Sedan V6-3.6L (BLV) (2008)
‹› Replace
‹› Tighten the fuel rail uniformly, starting from the inside and working toward the outside
2
Fuel Rail
‹› For cylinders 1, 3 and 5.
‹› Fuel injector springs - item 11 - must be replaced before installing.
‹› Tighten uniformly, starting from the inside and working toward the outside.
3
Spring Type Clip
4
Low Fuel Pressure Sensor (G410)
‹› 15 Nm
5
Fuel Supply Line
‹› From the fuel tank.
‹› With an exception for the fuel pressure sensor (G247).
6
Bolt
‹› 8 Nm
7
Bolt
‹› 8 Nm
8
Bracket
‹› For the fuel supply line.
9
O-ring
‹› Replace
‹› Before installing, lubricate with clean engine oil.
10
Support Washer
‹› Replace if damaged, refer to => [ Fuel Injector Teflon Seal and Washer ] See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service
and Repair/One Piece Intake Manifold.
11
Spring
‹› Replace for every removal of the fuel rail.
‹› Ensure the spring is securely seated.
12
Cylinder 1 Fuel Injector (N30)
‹› Cylinder 3 fuel injector (N32).
‹› Cylinder 5 fuel injector (N83).
‹› Removing and installing, refer to => [ Fuel Injectors ] See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/One
Piece Intake Manifold.
‹› The long fuel injectors for cylinders 1, 3 and 5 must not be separated.
13
Seal