Passat Sedan V6-3.6L (BLV) (2008)
-
Switch the ignition on.
-
Using a multimeter check the Fuel Pressure Sensor (G247) electrical harness connector for voltage.
-
Switch the ignition off.
If specified value is obtained:
-
Replace the Fuel Pressure Sensor (G247). Refer to the Repair Information.
If the specified value was not obtained:
Checking wiring connections
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to the Repair Information.
-
Using the a multimeter check the following wiring connection for an open circuit.