Passat Sedan V6-3.6L (BLV) (2008)
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to the Repair Information.
-
Using a multimeter, Check the Camshaft Position (CMP) Sensor 1 (G40) or Camshaft Position (CMP) Sensor 2 (G163) electrical harness
connector to the Motronic Engine Control Module (ECM) electrical harness connector T60 for an open circuit.
Specified value: 1.5 ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, high resistance or short circuit to voltage or ground.
-
Check the wiring connection for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring and voltage supply is OK:
-
Replace the Camshaft Position (CMP) Sensor 1 (G40) or Camshaft Position (CMP) Sensor 2 (G163) Refer to the Repair Information.
-
Erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.
-
Perform a road test to verify repair.
If the DTC does not return: