Passat Sedan V6-3.6L (BLV) (2008)
-
Perform a preliminary check to verify the customers complaint. Refer to => [ Preliminary Check ] See: Computers and Control Systems/Testing
and Inspection/Scan Tool Testing and Procedures/Preliminary Check.
Start diagnosis
Checking internal resistance
-
Disconnect the HO2S Oxygen Sensor Bank 2 Sensor 2 (G131) electrical harness connector - 3 -.
-
Using a multimeter, check the Oxygen Sensor Heater Bank 2 Sensor 2 (Z30) terminals 1 to 2 for resistance.
Specified value: 1.0 to 20.0 ohms (at approx. 20° C)
If the specification was not obtained:
-
Replace the faulty HO2S Oxygen Sensor Bank 2 Sensor 2 (G131). Refer to the Repair Information.
If the specification was obtained:
Checking voltage supply
Start the engine.
-
Using a multimeter, check the Oxygen Sensor Heater Bank 2 Sensor 2 (Z30)electrical harness connector terminal 1 to ground for voltage.
Specified value: 10.10 to 11.70 V
Switch the ignition off.