Passat Sedan V6-3.6L (BLV) (2008)
Headlamp Control Module: Service and Repair
HID Headlamp Power Output Stages
Headlamps
HID Headlamp Control Module
‹› Left High-intensity Gas Discharge Lamp Control Module (J343) and Right High-intensity Gas Discharge Lamp Control Module (J344) is not
capable of On Board Diagnostic (OBD).
‹› Illustrations depict replacement of High-intensity Gas Discharge Lamp Control Module at right headlamp.
‹› Replacement of Left High-intensity Gas Discharge Lamp Control Module and of Right High-intensity Gas Discharge Lamp Control Module is
identical.
Removing:
-
Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).
-
Remove headlamp, refer to => [ Headlamps ]. See: Lighting and Horns/Headlamp/Service and Repair/Removal and
Replacement/Headlamps/Headlamps
-
Remove mounting bolts - arrows - and pull High-intensity Gas Discharge Lamp Control Module - 1 - as far from headlamp as wire lengths allow.
-
Release the tab - arrow A - on the connector - 1 - and remove connector - 1 -.
-
Release retainer - 3 - on connector - 2 - in - direction of arrow B - and remove connector - 2 -.