Passat Sedan V6-3.6L (BLV) (2008)
Suspension Control Module: Service and Repair
Electronic Damping Control Module
Removing
Component location: behind the right side luggage compartment trim
-
Switch off all electrical consumers.
-
Remove the ignition key.
-
Remove the right luggage compartment side trim.
-
Remove the electronic damping control module (J250) - 1 - from the compartment.
-
Release and remove the connector - 2 -.
Installing
Installation is the reverse of removal, with special attention to the following:
-
Perform a basic setting on the adaptive chassis DCC. Refer to => [ Adaptive Chassis DCC, Basic Setting ] See: Steering and
Suspension/Suspension/Suspension Control ( Automatic - Electronic )/Testing and Inspection/Programming and Relearning.