Passat Sedan V6-3.6L (BLV) (2008)
‹› The screwdriver mentioned in the following should be about 175 mm long and have a blade width of 7 mm.
Removal
CAUTION!
‹› Read the Safety Instructions for working with airbags, belt tensioners and battery cut-out units.
‹› Note the special instructions for the driver and passenger airbags.
-
Switch on ignition.
-
Adjust steering wheel height to the highest position.
-
Adjust steering wheel depth (reach) so it is in the fully extended position.
-
Turn steering wheel into the position depicted.
-
Insert a screwdriver into hole on rear side of steering wheel until it stops (approx. 8 mm).
-
Turn the screwdriver in the direction of passenger side door - arrow -; this unlocks the airbag unit locking frame on the right side of the steering
wheel.
-
Turn steering wheel 180° and disengage airbag unit locking mechanism on left side of steering wheel as described.
-
Turn steering wheel back 90° into center position.
-
Switch off ignition.
-
Disconnect vehicle battery.
-
Remove airbag unit from steering wheel.