Passat Sedan V6-3.6L (BLV) (2008)
Tow Sensor: Service and Repair
Towing Recognition Control Module (J345)
Towing Recognition Control Module (J345)
Special tools, testers and auxiliary items required
‹› Torque Wrench (V.A.G 1783)
Removing:
-
Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).
-
Remove left side panel trim in luggage compartment.
-
Disengage connectors - 2 - and disconnect them from Towing Recognition Control Module.
‹› The number of connectors on the towing recognition control module can deviate from the illustration depending on the vehicle equipment.
-
Remove mounting bolts - 1 - and remove towing recognition control module with bracket out of vehicle.
-
Remove mounting bolts - arrows - and remove towing recognition control module from bracket.
Installing:
Install in reverse order of removal, noting the following:
‹› After installing a new towing recognition control module, it must be coded, refer to => [ Towing Recognition Control Module, Coding ] See: