Passat Sedan V6-3.6L (BLV) (2008)
-
Remove cover - A -.
-
Remove securing bolts - D - and remove Temperature Regulator Door Motor (V68) - B -.
-
Disengage control motor lever - E - from connecting rod - F -.
Installing
Installation is carried out in the reverse order. When doing this note the following:
-
Install the wiring harness so that it cannot come in contact with any moving parts (e.g. the actuating arm of the control motor).
‹› After installing Temperature Regulator Door Motor (V68), recirculating air door must be checked for function.
-
Checking: Vehicle diagnosis, testing and information system (VAS 5051B) or newer model.
-
Replace: Initiate the Basic Setting function with the vehicle diagnosis, testing and information system (VAS 5051B) (or newer model). Refer to =>
[ Climatronic A/C System, Checking and Adjusting Components ] See: Heating and Air Conditioning/Testing and Inspection/Component Tests
and General Diagnostics/Climatronic A/C System, Checking and Adjusting Components.
Air Distribution Door Motor, Climatic
Removing
-
Remove the instrument panel.
-
Disconnect the connector on the air distribution door motor (V428).
-
Remove the screws - 1 - and then remove the air distribution door motor (V428).
Installing
Install in reverse order of removal.
‹› After installing the air distribution door motor (V428) check the door function.
‹› Initiate "Basic Setting" function with Vehicle Diagnosis, Testing and Information System (VAS 5051B) (or succeeding model). Refer to => [
Climatronic A/C System, Checking and Adjusting Components ] See: Heating and Air Conditioning/Testing and Inspection/Component Tests and
General Diagnostics/Climatronic A/C System, Checking and Adjusting Components.
Center Outlet Temperature Sensor
Removing
-
Remove the instrument cluster.