Passat Sedan V6-3.6L (BLV) (2008)
Steering Column Combination Switch (E595), Through 10.09
Steering Column Switch
Steering Column Combination Switch (E595), Through 10.09
Special tools, testers and auxiliary items required
‹› Torque Wrench (V.A.G 1410)
Removing:
-
Disconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery, Disconnecting and Connecting.
Remove the following components in order:
-
Remove steering wheel.
-
Remove steering column trim.
-
Remove Steering Column Electronic Systems Control Module (J527). Refer to => [ Steering Column Electronic Systems Control Module,
Through 10.09 ]. See: Steering Column Electronic Systems Control Module (J527), Through 10.09
-
Remove Airbag Spiral Spring/Return Spring With Slip Ring (F138). Refer to => [ Airbag Spiral Spring/Return Spring With Slip Ring, Through
10.09 ]. See: Airbag Spiral Spring/Return Spring With Slip Ring (F138), Through 10.09
-
Remove segment sensor for steering column sensor. Refer to => [ Steering Angle Sensor Segment Sensor, Through 10.09 ]. See: Steering Angle
Sensor Segment Sensor, Through 10.09
-
Remove both bolts - arrows - on top side of Steering Column Combination Switch.
-
Pull off Steering Column Combination Switch toward rear from steering column.
Installing:
Install in reverse order of removal.
-
Tighten all threaded connections to the specification shown in => [ Fastener Tightening Specifications, Steering Column Switch Assembly ] See:
Specifications.