Passat Sedan V6-3.6L (BLV) (2008)
Specified value: 0.40 to 0.50 V
-
Switch the ignition off.
If the specified value was obtained:
-
Replace the HO2S Oxygen Sensor Bank 2 Sensor 1 (G108).
If the specified value was not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to the Repair Information.
-
Using a multimeter, check the HO2S Oxygen Sensor Bank 2 Sensor 1 (G108) electrical harness connector terminals to the Motronic Engine
Control Module (ECM) (J220) electrical harness connector T94 terminals for an open circuit.