Passat Sedan V6-3.6L (BLV) (2008)
-
Fold the bench seat forward.
All vehicles
-
Remove side upholstery:
‹› with rear side airbags, refer to => [ Side Upholstery with Side Airbag ] See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Rear Seats
‹› without rear side airbags, refer to => [ Side Upholstery without Side Airbag ] See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Rear Seats
-
Remove the wheel housing trim around the rear side airbag crash sensor (on driver's side) (G256) out of the retainers. Refer to => [ Wheel
Housing Trim ] See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair
-
Press connector lock - 1 - and disconnect connector - 2 - from Rear Side Airbag Crash Sensor (driver side) (G256) - 3 -.
-
Remove the two bolts - 4 - (9 Nm).
‹› Alternatively, the Rear Side Airbag Crash Sensor (on driver's side) (G256) may be secured by a single screw.
Installation
-
To install, perform the steps used for removal in reverse order.
-
Switch on ignition.
CAUTION!
Make sure that no persons are in the vehicle.