Passat Sedan V6-3.6L (BLV) (2008)
/Page-324010.png)
Passive Occupant Detection System Components, Power Seats
CAUTION!
Observe safety precautions when working on seat occupied recognition. Refer to => [ Passive Occupant Detection System Safety
Precautions ] See: Passive Occupant Detection System (Overview).
‹› Seat cushion, mat for seat occupied recognition, control module and pressure sensor must only be replaced together. Components are
complementary and must not be separated!
‹› Only disconnect wiring harnesses mentioned in the following description!
-
Mount the (VAS 6136) on the (VAS 6095).
-
Perform the following seat adjustment:
‹› Seat height: highest position
‹› Seat tilt: highest position
-
Remove front seat. Refer to => [ Front Seat ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seats
-
Attach the seat to the (VAS 6136).
-
Remove the front seat belt latch. Refer to => [ Front Seat Belt Latches ] See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair
-
Remove seat cap. Refer to => [ Cover Cap ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seats
-
Remove electric seat front end trim. Refer to=> [ Power Seat Front Side Trim ] See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seats
-
Remove electric seat trim. Refer to => [ Power Seat Trim ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seats
-
Remove electric seat trim bracket. Refer to => [ Power Seat Trim Bracket ] See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seats
-
Disconnect connector - 1 - from height adjustment motor.
-
Depending on vehicle equipment, operate locking mechanisms of individual harness connectors and disconnect the corresponding wiring harnesses
from main wiring harness - 1 -.
-
Loosen main wiring harness from seat frame.
-
Disconnect individual harness connectors from wiring harness of backrest - 2 - on seat frame.
‹› White mount must not be loosened.
