Passat Sedan V6-36L (BLV) (2008) Starting and Charging: Keyless Start Antenna Overview
‹› No coding, basic setting or adaptation is necessary if Access/Start Authorization Antenna In Rear Bumper is replaced. Erase the entry in the DTC
memory in "Guided Fault Finding" with the Vehicle Diagnosis, Testing and Information System (VAS5051B). Refer to => [ Access/Start
Authorization Antenna In Rear Bumper, Checking ] See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Testing
and Inspection/Component Tests and General Diagnostics/Antennae and Sensors For Access/Start Authorization, Checking.
Removing:
-
Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).
-
Remove rear bumper cover.
-
Disengage Access/Start Authorization Antenna In Rear Bumper - 1 - from lower section of bumper, paying attention to lengths of connected
wires.
-
Disengage and disconnect harness connector - 2 - and remove Access/Start Authorization Antenna In Rear Bumper - 1 - from vehicle.
Installing:
Install in reverse order of removal, noting the following:
-
Connect harness connector - 2 - to the Access/Start Authorization Antenna In Rear Bumper - 1 - until it engages.
-
Insert Access/Start Authorization Antenna In Rear Bumper - 1 - first into mount in bumper base and then press it into its end position until it
engages.
Interior Access/Start Authorization Antenna 1
Access/Start Authorization Antennas and Sensors