Passat Sedan V6-3.6L (BLV) (2008)
CAUTION!
The chips must not get into the steering column.
-
Turn the steering column 180° tension it in the vice.
-
Carefully move the universal joint - 2 - downward.
‹› It is necessary to turn the steering column 180° so that any chips that may fall down from above when loosening the shear bolt cannot get into the
steering column.
-
Loosen the lower shear bolt - arrow - using the (T10424).
-
Remove any chips with a brush.
-
Remove the electronic steering column lock control module (J764) - 1 -.
Installing
-
Install the electronic steering column lock control module - 1 - with new shear bolts - arrows -.
-
Tighten the shear bolts - arrows - evenly until the bolt heads shear off.
-
Install steering column. Refer to => [ Installing ] See: Steering/Steering Column/Service and Repair/Removal and Replacement/Steering Column.
-
If the steering column with an electronic steering column lock control module was replaced, then the electronic steering column lock control
module must be adapted using the (VAS 5051).
Guided Functions