Passat Sedan V6-3.6L (BLV) (2008)
This prevents damage to the control module - 1 -.
Installing
Installation is performed in the reverse order of removal.
Steering gear threaded sleeves must sit in bracket holes.
‹› Coat seal on steering gear with lubricant, e.g. soft soap, before installing steering gear.
‹› After placing steering gear onto universal joint, make sure that seal on steering gear makes contact on assembly plate without kinks and opening to
footwell is correctly sealed. Ingress of water and/or noises may be the result.
‹› Make sure sealing surfaces are clean.
Before fastening the bolts for subframe, position steering gear on subframe and fasten bolts for steering gear and stabilizer.
-
Install the lower noise insulation.
-
Bolt universal joint to steering gear.
-
Connect battery.
-
Perform a basic setting on the steering angle sensor (G85) with (VAS 5051).
If a new steering gear was installed, then the electromechanical steering must be adapted with the (VAS 5051).
-
Adapt the electro-mechanical power steering with the (VAS 5051).
Suspension
Electromechanical Power Steering
01 - On Board Diagnostic (OBD) Capable Systems
Electromechanical Power Steering
Functions
Adapting the Electromechanical Power Steering
‹› If the vehicle has Park Assist, then the Power Steering Control Module (J500) must be re-coded after a new steering gear has been installed.
After installation, position of steering wheel must be checked with a road test.
If steering wheel is at an angle or a new steering gear was installed, vehicle must be aligned.