Passat Sedan V6-3.6L (BLV) (2008)
Installation is performed in the reverse order of removal. Pay attention to the following:
-
Lubricate the outer circumference and sealing lips of the seal with Automatic Transmission Fluid (ATF).
-
Drive in the seal until seated using (T10105), do not tilt the seal while doing this.
-
Install the drive axle.
-
Check the ATF level and top off if necessary. Refer to => [ Automatic Transmission Fluid Level, Checking and Filling ] See: Fluid - A/T/Service
and Repair/Automatic Transmission Fluid Level, Checking and Filling.
-
Install the noise insulation.
Right Flange Shaft Seals (AWD)
Right Flange Shaft Seals
=> [ Small Seal ]
=> [ Large Seal ]
‹› The bevel box is removed.
Remove the bevel box, refer to one of the following:
Passat and CC, refer to => [ Bevel Box ] .
Tiguan, refer to => [ Bevel Box ] .
Special tools, testers and auxiliary items required
‹› Torque Wrench (40-200 Nm) (V.A.G 1332)
‹› Seal Puller (T10397)
‹› Seal Puller (T10398)
‹› Assembly Tool (T10399)
‹› Thrust Piece (T10400)
Small Seal
Removing
-
Install the (T10397) to the inside the seal - 2 -.