Passat Sedan V6-3.6L (BLV) (2008)
-
Disconnect the cable from the selector lever. To do so, press the pin upward using a screwdriver, at the same time push the securing catch for the
pin forward - arrows -.
-
Remove the locking washer for the cable cover. Always replace the locking washer.
-
Remove the selector lever cable.
Installing
-
Loosen the cable adjustment bolt.
Do not grease the cable.
-
Route the selector lever cable free of tension, also insert it into the bracket on the transmission but do not secure it yet.
-
Also clip the cable in the retainer. Make sure that the retainer does not make contact with the oil cooler.
- Nuts - 8 Nm