Passat Sedan V6-3.6L (BLV) (2008)
16- Gasket
^
Bonding surface on constant velocity joint must be free of grease and oil!
17- Inner constant velocity joint
^
Replace only as complete unit
18- Dished washer
Drive Axle with Constant Velocity Joint VL 107 Assembly Overview
Drive Axle with Constant Velocity Joint VL 107 Assembly Overview
1- Outer constant velocity joint
2- Bolt
^
M16 x 1.5 x 80
^
Hex head bolt = 200 Nm plus an additional 180° turn
^
12-point bolt = 70 Nm plus an additional 90° turn
^
Always replace after removal
^
Vehicle must not stand on wheels when loosening and tightening
3- Securing ring
^
Always replace after removal
4- Thrust washer
5- Dished washer
6- Clamp
^
Always replace after removal
7- Protective boot
8- Clamp
^
Always replace after removal
9- Drive Shaft
10- Clamp
^
Always replace after removal
11- CV boot
^
Before mounting onto constant velocity joint, coat sealing surface using D 454 300 A2
12- Clamp
^
Always replace after removal
13- Backing plate
^
Always replace after removal
14- Cover
^
Before mounting onto constant velocity joint, coat sealing surface using D 454 300 A2
15- Inner constant velocity joint
16- Gasket