Passat Sedan V6-3.6L (BLV) (2008)
-
Remove brake carrier with brake caliper and hang on body with tie wire.
‹› Suspend brake caliper from body.
-
Remove brake disc bolt and take out brake disc.
-
Remove multi-point socket head bolt using bit XZN 18 (T10162).
-
Pull wheel hubs/wheel bearing unit off stub axle.
Installing
-
Carefully slide wheel hub/wheel bearing unit onto stub axle.
‹› Make sure that wheel hubs/wheel bearing unit do not cant!
-
Tighten using a new multi-point socket head bolt.
‹› First tighten bolt to specified tightening specification using torque wrench.
‹› Use solid wrench for additional torque angle.
-
Drive in dust cap using (3241/4).
‹› Always replace dust caps.
‹› Damaged dust caps allow moisture to enter. Therefore, always use the tool shown.
Rest of installation is the reverse of removal.