Passat Sedan V6-3.6L (BLV) (2008)
-
Place the drip tray (VAS 6208) under the rear final drive.
-
Remove oil fill plug - arrow -. (Shown with final drive removed for the sake of a better illustration).
The oil level is correct if the Haldex clutch is filled to the lower edge of the oil fill plug hole or up to 3 mm below the oil fill hole.
-
Install the fill plug and tighten. Tightening specification: 15 Nm.
Filling
Requirements
‹› Vehicle must be on a flat surface
-
Fill with high performance Haldex clutch oil.
High performance oil for the Haldex clutch is available as a replacement part.
-
Raise vehicle.
Vehicles with a Crossmember
-
Cover the crossmember with a cloth.
If oil gets on the crossmember or enters the perforations in the crossmember, it must be removed.
-
Use the charging device for Haldex 2 couplings (VAS 6291) to add oil.