Passat Sedan V6-3.6L (BLV) (2008)
‹› For the Passat CC and Tiguan, refer to => [ Driveshaft Assembly Overview ] See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Removal and Replacement/Driveshaft Assembly Overview From 07.07.
Passat
-
Secure the vehicle on the hoist with the tensioning straps (T10038).
Continuation for All
CAUTION!
If the vehicle is not secured, there is the risk that it could slip from the hoist.
-
Remove the rear final drive flange nut.
A Bolts M10 x 25
B Bolt M8 x 15 (installed in the counter support (3415) from the rear side)
-
Remove the rear final drive flange. Use a slide hammer (Kukko 12/1) if it is difficult.