Passat Sedan V6-3.6L (BLV) (2008)
-
Drive in rear final drive flange with sleeve (30 - 20).
-
Insert new nut with locking fluid (D 000 600) and tighten to specifications.
A Bolts M10 x 20
B Bolt M8 x 15 (installed in the counter support (3415) from the rear side)
-
Install the rear flexible disc:
‹› For the Passat, refer to => [ Rear Flexible Disc ] See: Drive/Propeller Shafts, Bearings and Joints/Universal Joint/Service and Repair.
‹› For the Passat CC and Tiguan, refer to => [ Driveshaft Assembly Overview ] See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Removal and Replacement/Driveshaft Assembly Overview From 07.07.
-
Install the exhaust system and align it without tension.
-
Check the oil level in the Haldex clutch:
‹› For the Passat, refer to => [ Generation II Haldex Clutch Oil Level, Checking and Filling ] See: Final Drive Fluid/Service and Repair/Generation
II Haldex Clutch Oil Level, Checking and Filling.
‹› For the Passat CC and Tiguan, refer to => [ Generation IV Haldex Clutch Oil Level, Checking and Filling ] See: Final Drive Fluid/Service and
Repair/Generation IV Haldex Clutch Oil Level, Checking and Filling.
Tightening Specifications