Passat Sedan V6-3.6L (BLV) (2008)
Wiper Arm: Procedures
03 - Service Procedures
Windshield Wiper Protectors, Removing
There are currently three ways to remove a wiper protector from a wiper blade or to replace a transport wiper arm.
Version 1
These wiper arms with protective rails can be identified by the two fasteners - arrows - that secure the protective rails on the wiper arm.
Perform the following procedure:
-
Place the windshield wiper in the service position. To do this, switch the ignition on and off again once with the hood closed. Then press the wiper
lever and the windshield wipers will stay in the service position.
-
Remove the right windshield wiper from the windshield and fold it upward.
CAUTION!
To avoid damage, only hold the windshield wiper at the wiper joint and do not pull on the wiper blade.
-
Now pull the upper fastener upward and the lower fastener downward - arrows -.