Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
Door Lock Knob: Service and Repair
Securing Knob For Locking Rod, Removing And Installing
-
Following descriptions of removing and installing securing knob must always be observed.
-
If disregarded, locking rods may rotate out of front door locks and relays may rotate into rear doors/damage mounts.
Removing
Right front and left rear doors
-
Remove securing knob 180° to left.
-
Remove securing knob upward in direction of - arrow -.
Installing
Right front and left rear doors
-
Attach securing knob onto locking rod with marking -small point on top side- toward vehicle interior side.
-
Press securing knob onto locking rod in direction of - arrow - only as far until corrugation is at height of door trim.
-
Install securing knob 180° to left.
When locked, securing knob can be approx. 02 mm over door trim.
Removing
Left front and right rear doors
-
Remove securing knob 180° to right.