Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
Wheel Speed Sensor: Service and Repair
Components of ABS System on Front and Rear Axles
Parts of ABS system on front and rear axles, removing and installing
Components of ABS system on front axle removing and installing
Note: Removing and installing ABS system parts is identical for all brake calipers.
1 - ABS speed sensor
^
Before inserting sensor, clean inner surface bore hole and coat with lubricating paste G 000 650
2 - Drive shaft with rotor
^
Check rotor for damaged or dirt
3 - Hex bolt
4 - Clamping sleeve
^
Always replace
^
Left and right side identical
^
Before inserting into wheel housing, coat circumference with grease G 000 650
^
Push into wheel bearing housing up to stops
5 - Sealing cuff
Removing and installing speed sensor on front axle
Removing
^
Loosen wheel bolts.
^
Raise vehicle.
^
Remove wheel.