Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
Brake Pedal Assy: Service and Repair
Brake Pedal - Assembly Overview
Brake pedal - assembly overview
WARNING! Brake pedal travel must not be restricted by additional floor covering.
1 - Mounting bracket
2 - Pivot pin for clutch and brake pedal
^
Installation position: The groove (arrow) faces towards clutch pedal.
3 - Locking clip
4 - Hex socket head bolt, 25 Nm
5 - Brake pedal
6 - Clutch pedal
7 - Pin
^
Always replace
8 - Locking clip
9 - Master cylinder
10 - Hex socket head bolt, 20 Nm
11 - Mounting
^
Install in mounting bracket with over-center spring
^
Installation position: Deep groove faces downward
^
Use Parts Supplier to check correct application
12 - Over-center spring
^
Allocation: Parts Supplier
13 - Hex socket head bolt, 5 Nm
^
Securing clutch pedal and brake pedal pivot pin
14 - Seal
15 - Torx screw, 25 Nm
^
Secures the brake master cylinder and brake servo