Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
^
Remove brake pedal.
Installing
Installation is carried out in the reverse sequence, note the following:
^
Do not tighten socket head bolt -3- until retaining clip has been installed to clutch and brake pedal pivot pin.
Joining brake pedal to brake servo
^
Hold push rod ball head in front of mounting and push brake pedal in direction of brake servo until ball head engage audibly.
^
Adjust brake light switch and, if necessary, brake pedal switch, Refer to Lighting and Horns, Brake Light Switch, Adjustments