Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
^
Bolt brake caliper housing to brake carrier with both guide pins.
^
Install both protective caps.
The brake wear indicator wiring must be routed beneath the bracket on the brake caliper.
^
Install brake pad wear indicator connector under dust cap of bleed valve, in upper protective cap and in bracket on brake caliper.
^
Install brake wear indicator connector into bracket on brake caliper.
^
Install retaining spring into brake caliper housing and then press under brake carrier.
Note:
^
After each brake pad change with vehicle stationary, firmly depress brake pedal several times so that the brake pads are properly seated in their
normal operating position.
^
Check brake fluid level, after changing brake pads.