Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
-
Loosen hex bolts -1-, -2-, -5-, -6-, -7- and -8-.
-
Turn bolt -2- until the specifications are achieved.
Specifications for vehicle alignment, Refer to alignment specifications.
-
Relieve tension on bolt -2- and check the readings obtained, if necessary correct camber again.
-
Screw in new hex bolts -7- and -8-.
-
Remove camber adjustment device --VAG 1941-.
-
Screw in new front hex bolts -5- and -6- and tighten, Refer to Front Suspension, Service and Repair, Front Suspension, Servicing, See item 28.
-
Tighten new hex bolts -1-, -2-, -3- and -4- , Refer to Front Suspension, Service and Repair, Front Suspension, Servicing, See - item 27.
Important: The toe must be checked after each camber adjustment.