Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
/Page-1719002.png)
-
Remove bolts -1- for cover plate.
-
Disconnect ABS speed sensor from wheel bearing housing.
-
Remove nuts -2- and -3-.
-
Remove rubber grommet -1- and separate connector -2-.
-
Disconnect ABS speed sensor wiring from retainers -arrows-.
-
Guide wiring through opening in wheel bearing housing and take out.
Note: Do not damage the rubber grommet!
-
Remove hex bolt -3- and nut -4-.
-
Remove track rod ball joint.
-
Remove nut from joint pin.
-
Press guide link joint pin out of tapered seat.
