Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
-
Tighten hex nut of tensioning bolt (Torx T50, Refer to Steering Gear, Service and Repair, Steering Gear, Assembly, Overview, See item 5.
-
Now remove tool -VAG 1907- from steering gear.
1. hex socket head bolt
2. Threaded hole in steering gear
-
Seal steering gear with hex socket head bolt.
-
Install universal joint to steering pinion.
-
Remove steering column assembly aid.
-
Install driver's side stowage compartment.
-
Install wheel housing cover.
-
After completely installing steering gear remove hose clamps -3094-.
-
Turn ignition key to position "ignition off".
-
Install battery and enter code for radio if necessary.
-
Install noise insulation tray.
-
Install wheel and tighten.
-
Check hydraulic oil.
-
Check steering system for leaks.
-
Bleed steering system.
After installing check position of steering wheel during a test drive.
If steering wheel is not in straight ahead position the front axle tracking must be checked and if necessary adjusted!
-
Check toe adjustment.