Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
/Page-1313003.png)
-
Remove screw -1- from secondary ATF cooler -arrow A-.
-
Remove screw -2- from holder -arrow B-.
-
Remove bolt -3- from secondary ATF cooler -arrow A- and remove secondary ATF cooler.
Installing
-
Insert secondary ATF cooler -arrow A- and tighten screws -3-.
-
Tighten screw-2- on holder-arrow B-.
-
Tighten screw -1- on secondary ATF cooler -arrow A-.
-
Always replace O-rings -1-.
-
Moisten O-rings -1- with ATF.
-
Ensure that O-rings are seated correctly so they do not slip out of position when ATF lines are inserted.
-
Insert ATF lines -2- by hand into secondary ATF cooler until they can go no further.
-
Do not tighten screws -3- Until ATF lines have been fully inserted.
-
Check ATF level and top up.
