Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
/Page-1385001.png)
Wiring Harness: Service and Repair
Transmissions With Hydraulic Control Type E18/2
Transmissions with hydraulic control Type E18/2
Removing
Remove valve body.
-
Using a small screwdriver, pry out retaining tabs on solenoid valve connectors, and pull off connectors -A- one after the other.
-
Disengage wiring harness from retainers -B- on side of valve body.
-
Turn valve body over onto back and remove connector from pressure control valve 1 (-N 125-) -1-.
-
Remove first retaining clip -arrow A and unclip harness from second retaining clip -arrow B-.
Installing
-
Install in reverse order but note following:
-
When fitting the harness, plug the connectors onto the respective solenoid valves.
-
Clip the harness into the retaining clips provided. If not fitted correctly, the harness can be trapped when the valve body is installed.
-
Install valve body.
-
Fill with ATF; check ATF level and top up.
