Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
Install shims as follows:
-
Loosen plastic nuts on assembly device -arrows A- until intermediate bearing retaining bracket-2- has clearance -a- on one side to stud -1-.
-
Place shim as measured -1- on stud and swing intermediate bearing retaining bracket -2- to other side.
-
Place 2nd shim -4- on stud -3-.
-
Tighten both plastic nuts on assembly device -arrow A-.
Center driveshaft longitudinally:
-
Slide driveshaft to rear onto stop with assembly appliance.
-
Mark position of intermediate mount on body (arrow -A-).
-
Slide driveshaft forward onto stop with assembly appliance.