Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
-
Now remove the shift lever housing securing nuts -1-.
The shift lever housing is lowered due to this.
-
Remove slide rod, to do this remove hexagon socket head bolt-2-.
-
Remove slide rod, to do this remove hexagon socket head bolt -3-.
-
Now release complete rear slide rod from shift lever housing (arrows).
-
Remove shift lever with rear slide rod from shift lever housing.
Installing
Installation is carried out in the reverse sequence, when doing this note the following:
Tightening torques
Rear slide rod to transmission 6 Nm
Selector rod to shift fork/shift lever 25 Nm
Front slide rod to rear slide rod 25 Nm
Shift lever housing to body 10 Nm
Shift lever housing cover to rear slide rod 10 Nm