Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
Tolerance
± 2°
Adjust contact angle to specification, if required, as follows:
-
Place 24 mm open end wrench -1- on setting device and adjust wiper arm -2- to specification -arrows-.
-
Release wiper arm -2- from adjusting tool and secure with locking screw -3-.
-
Compare value set with table. Repeat adjustment and check sequence until specifications are achieved.
-
Remove setting device and install wiper blade.
Wiper arm tightening torque: 20 Nm (15 ft. lb)
-
Check that wiper system operates without skipping.